+64 9 624 5312

Welcome to the Wholesale Blind Factory

How to Measure for Roller Blinds

Measuring roller blinds

Getting the right size is very important to the overall look and performance of your roller blinds. Take your time and follow the old builder's rule of thumb - measure twice.

Sketch each of your windows and write each measurement on the sketch as you go.

Always measure in millimetres with a reliable tape measure.

measuring for an inside mount roller blindFor an Inside Frame Mount

Note: To mount your blind inside the window frame you will need at least a 65mm deep recess.

  1. Measure the exact opening width across the inside of the window frame in millimetres at the top, middle and bottom of the window as pictured in positions A, B and C. Use the smallest of the three measurements for your roller blind.
  2. Measure the exact drop (or height) of the opening from the inside top of the window frame to the top of the sill in millimetres as pictured as measurement D.

For an Outside Frame Mount

Instructions for measuring for an outside mounted roller blind

  1. Measure the required width of the blind in millimetres (usually from the outside edge of the frame or architrave or wider if desired). If the window has no architrave or frame you will need to add at least 40mm on each side of the opening.
  2. Measure the required drop (or length) from the top of the architrave or frame.
    • At the top, a minimum of 30mm of frame/architrave is required for the fixing of the control brackets. If there is less than a 30mm frame, measure from a point at least 40mm above the window.
    • Where there is a protruding sill, measure to the top of the sill. If there is no protruding sill you may choose a point lower than the sill.